警告：
树脂可能引起皮肤刺激或皮肤过敏反应。处理液态树脂或树脂涂层表面时，请戴上手套。用大量肥皂和水冲洗皮肤。
白皮书
Reprogramming a resin tank (Form 4 and Form 4L generation)
Reprogramming a resin tank (Form 4 and Form 4L generation)
There may be circumstances where you need to reprogram a Form 4 or Form 4L generation resin tank so it can be used with a different resin type. For example, you may have started a print with a new resin tank but inserted the wrong resin cartridge. In this case, you can use the printer’s touchscreen to reprogram the resin tank to accept a new resin type.
清洁树脂槽
如果树脂槽中尚有树脂，必须先将其清除并将树脂槽清理干净，然后才能重新编程。
- Inspect the tank to ensure that it is free of debris.
- Pour the resin from the resin tank into an opaque, resin-safe container.
- Wipe any remaining resin from the resin tank using a soft sided tool, squeegee or scraper.
Notice:
- Do not pour resin from the resin tank back into the corresponding resin cartridge. Doing so may contaminate the resin in the resin cartridge.
- Take extreme care not to damage the tank film when cleaning the tank. Using a sharp tool can scratch, puncture, or deform the film. Damaged tanks may impact print quality or cause resin spills.
将树脂槽重新编程
After thoroughly cleaning your resin tank, insert the tank into the printer to begin the process of reprogramming.
注意：
重新编程前，应确保树脂槽清理干净，没有树脂残留。如果树脂槽中混有不同类型的树脂，则可能损坏树脂槽或对打印造成不良影响。
- Insert the cleaned resin tank into the printer.
- Upload a print job to the printer that requires the resin type you want to assign to the resin tank.
- Insert a resin cartridge that matches the print job.
- Start the print. The printer displays Error 1.6.10: Incorrect tank inserted.
- Tap Ignore. A confirmation screen appears.
- Confirm that you want to reprogram the resin tank. The resin tank is reprogrammed to match the print job.
Notice:
Reprogramming a tank for use with a biocompatible resin may impact the biocompatibility of your printed parts. You acknowledge and agree that reprogramming is at your own risk and Formlabs is not liable for any adverse results that may occur. You are responsible for testing and validating your printed parts to ensure they meet your specifications and biocompatibility requirements.